Ryan Yao

1. Install the 200mm field lens after removing the 110mm lens by screwing by hand2. Re-adjust the focus as focus length will change with the new lens. Please refer to the below Appendix 1 to Adjust...

1. Click Material Library to open the library window.2. Click Load to import a .clb file. 

1. Click Material Library to open the library window.2. Click Load to import a .clb file. 

1. Install the selected field lens. 2. Power on the laser and make sure the machine is connected to the software. 3. Go to Device Setting → Other and check the pop-up window.          4. If you are...

The relative position of laser head needs to be adjusted so as to achieve bigger engraving area. The specific operation steps are as follows: Note： The 300mm field lens is not included as standard ...

1. Install the 200mm field lens after removing the 110mm lens by screwing by hand2. Re-adjust the focus as focus length will change with the new lens. Please refer to the below Appendix 1 to Adjust...

 ⚠Please make sure before engraving: Follow the user manual to install ComMarker Studio and assemble the machine with the computer.Remove the lens cap.Power on the engraver. 1. Secure the material ...

Check if you have both rollers and slides plugged into the machine.Check the Rotary or Slide connection. The connector on the accessory must be on the left side of the machine (the red Emergency St...

⚠Please make sure before engraving: Follow the user manual to install ComMarker Studio and connect the engraver to your computer.Remove the lens cap.Power on the engraver. Note: To avoid interrupti...

Download and install Lightburn software from the website. Note:  It is not compatible with our machine if your Lightburn version is lower than V1.3.01, please download a new version and reinstall. ...