Ryan Yao

List of items Product StructureSpecificationsAssembly of Machine1. Place the parts on the table 2. Fix the supporting shelf onto the supporting pole 3. Put the laser head on the supporting shelf an...

ParametersAccessories  Product StructureAssembly of Machine1. Place the parts on the table 2. Place the coupling on the right place of the shaft 3. Fasten the coupling with the inlaid screws 4. Fas...

1. What is a UV Laser EngraverA UV laser engraver uses 355 nm ultraviolet light for precise marking with minimal heat, preventing charring or discoloration. Its short wavelength enables nano-level ...

Troubleshooting Guidance Potential Problems Possible Solutions No Laser Output Correct the focus by adjusting the height of the laser arm. Correct the software parameters if they are invalid or...

Product StructureList of itemsAssembly of Machine 1. Place the parts on the table. 2. Install the rubber feet with screws.  3. Fasten the supporting pole with screws.  4. Fix the laser head on the ...

Troubleshooting Guidance Indicator Light Status  Possible Solutions  Green light on,  Red light off,  Laser beam on but no power 1. Check if the laser signal cable is connected correctly....

Product StructureList of itemsAssembly of Omni 1 Machine 1. Place the parts on the table. 2. Fasten the supporting pole with four screws. 3. Fix the laser head on the shelf. 4. Connect the external...

Troubleshooting Guidance  Potential Problems  Possible Solutions  No Laser Emission Recalibrate focal length by adjusting laser arm height.  Verify and correct software parameters if erroneous....

⚠Please make sure before engraving: Follow the user manual to install ComMarker Studio and assemble the machine with the computer.Remove the lens cap.Power on the engraver. 1.Set up ComMarker COX i...

If an admin password is required while using the ComMarker Studio , use the default: 123456.Note: Please be aware that changing device settings may affect the operation of the machine. If you encou...