Ryan Yao

⚠Please make sure before engraving: Follow the user manual to install ComMarker Studio and assemble the machine with the computer.Remove the lens cap.Power on the engraver.  1. Turn on ComMarker St...

Troubleshooting Guidance  Potential Problems  Possible Solutions  No Laser Emission Recalibrate focal length by adjusting laser arm height.  Verify and correct software parameters if erroneous....

Product Name Omni XE Voltage  110V or 220VField Lens Specification 70*70mm /150*150mm Working Area (With Slide Extension) 5.9"*5.9" (150mm*150mm) (5W Model)5.9"*15.7" (150mm*400mm) (5W Model)9.8"*9...

1. Maintenance OverviewNOTE: Unless otherwise specified, perform adjustment and maintenance ofthis device only when the power is turned off and the power supply has been disconnected. Only trained ...

List of items Product StructureSpecificationsAssembly of Machine1. Place the parts on the table 2. Fix the supporting shelf onto the supporting pole 3. Put the laser head on the supporting shelf an...

ParametersAccessories  Product StructureAssembly of Machine1. Place the parts on the table 2. Place the coupling on the right place of the shaft 3. Fasten the coupling with the inlaid screws 4. Fas...

Product Name  Omni X  Voltage   110V or 220V Field Lens Specification  70*70mm /150*150mm  Working Area  (With Slide Extension)  5.9"*5.9" (150mm*150mm)  5.9"*15.7" (150mm*400mm)  Mar...

List of Items  Install the Slide Extension onto the machine1. Lift the safety door, engage the sliding axis with the machineʼs work base, and fix the sliding axis onto the work base. Note： Please e...

⚠Please make sure before engraving: Follow the user manual to install ComMarker Studio and assemble the machine with the computer. Fix the rotary axis onto the platform and connect it to the correc...

Troubleshooting Guidance Potential Problems Possible Solutions No Laser Output Correct the focus by adjusting the height of the laser arm. Correct the software parameters if they are invalid or...