Cutting with ComMarker COX

⚠Please make sure before engraving: 

Follow the user manual to install ComMarker Studio and assemble the machine with the computer.

Remove the lens cap.

Power on the engraver.

1.Set up ComMarker COX in ComMarker Studio and verify lens selection

Troubleshooting: If unsuccessful, please refer to the "Preparation Before Engraving" section to complete the startup check.

2.Place a piece of paper from the material pack and ensure the left red dot lands on the surface.

Note:

To protect your device, please place a backing board beneath it before focusing. The board should be flat and opaque. You may also purchase compatible Cutting Panel or a Metal Sheet Holder available at ComMarker UV & Fiber Laser Engravers | Industrial Precision Engraver

3.Click the “Focusˮ button to set the autofocus. Once focusing is complete, a confirmation window will appear.

Troubleshooting: If focusing failed, please refer to the "Focus Readjust Needed with ComMarker Studio" section for detailed diagnosis and solutions.

4.Use “Drawˮ to draw a circle and disable fill

5.Input the engraving setting.

Note: If the settings panel does not appear, select the design from the Graphics list to activate it.

6.Click Preview Contour, then click Preview to check the engraving position and path.

7.You can move the text on the canvas to change the engraving spot and size. Once the preview is confirmed. Click "Stop" to exit

8.Click “Start (F2)ˮ to begin engraving.