How to Perform 3D Inner Engraving

⚠Please make sure before engraving: 

Follow the user manual to install ComMarker Studio and assemble the machine with the computer. 

Install the 70×70 field lens and select the corresponding lens setting in the software. 

Remove the lens cap. 

Power on the engraver.

Note:

To avoid interruptions, please disable screen sleep settings or ensure the computer remains active until the engraving process is complete.

1. Click the “3D Glassˮ module, import your STL file through “importˮ

Tips:

STL is a 3D file format used for modeling and printing. You can find good STL files on various 3D model community websites.

2. Measure the actual size of your workpiece and enter them in the “Crystalˮ section.

3. Use the Scale slider to resize the model so that it fits properly inside your workpiece.

3.1 (Optional) If the model isn’t oriented correctly, use the Move and Rotate tool at the bottom to adjust its X, Y, or Z angles until it faces the right direction.

4. Input the following settings in the section below.

5. Click on the gear icon next to "Laser Setting" to open the panel for crystal engravings parameters. Input “Galvanometer Speed: 4000ˮ.

6. Set the red dot on the engraving bed and click Focus.

7. Put the workpiece on the engraving bed.

Note：

Always complete the focusing process before placing the workpiece.

8. Click Preview and use the preview helper to check if the border aligns with your workpiece. Once confirmed, remove the helper and close the safety door.

9. Click Start to begin engraving. After the engraving is finished, wait for the laser to stop, remove the workpiece.

Note：

The Deflecting process before engraving may take a few minutes. Please do not exit. You will see the Processing window once deflecting is done.