(Optional) B6 MOPA Auto Focus Setting

Setting of auto focus software is optional because the machine was well set before sending out. 

The following instruction is for your reference just in case something goes wrong with the machine

Controlling Page

	Lift up: the laser head will go up when pressing the button
	Auto focus: the laser head will move the right focal length according to the original setting
	Lift down: the laser head will go down when pressing the button
	WARNING: The sensor in the machine only works in the range of 120mm to 280mm; this warning will pop up while it is out of the range. Please lift up or down manually to adjust the focus distance in between 120mm and 280mm.

Setting Page

	Lift up: the laser head will continuously go up when pressing the button when tapping the button
	Auto focus: the laser head will move the right focal length according to the setting parameters above
	Lift down: the laser head will continuously go down when pressing the button when tapping the button
	Stop: the laser head will stop when it is continuously moving

Speed: 12.5mm/s. This is an optimized parameter adjusted by the manufacturer.

Screw pitch: 8mm for ComMarker B6. Indicate distance between two adjacent threads on a screw. 

Pulse count：200 round Indicate the number of pulses required for the stepper motor to complete one revolution. 

Focal length：the distance from the inner sensor to the engraving surface, the laser head will go up or down according to this focal length number when pressing “Auto” button the focal length number can be input by press the button “Send focus”

Real focal length: display the current focal distance while the laser head goes up or down 

Send focus: Input the number displayed on “Real Focal length” onto “Focus Length” 

OK: parameters will be stored by the control board by clicking “OK”. The Auto button will run according the parameters 

EN/中：change the language into Chinese or English

For more instructions and specifications, View Full ComMarker B6 MOPA Manual↗