B6 Safety First

Safety Warning

NOTE: 

Before using the laser engraving machine, please read this safety guide carefully

• Do not leave the device unattended while in operation. Ensure it is functioning properly at all times.  
• Check the machine for damage every time before you use it. Do not operate it in any way when any damage or defect is found.
• Inspect the machine for damage before each use. Do not operate if any damage or defects are detected. Ensure the workspace is clean and level.
• Do not disassemble or alter the machine's structure without authorization. Do not modify or decompile its operating system.
• Keep the interior of the machine clean. Accumulated residues and debris from cutting and engraving can be hazardous and may cause afire. Regularly clean the work area to remove chippings and residues.

1. Laser Safety

• The machine uses Class IV lasers, which are extremely powerful and can cause eye injuries or burn the skin. It is recommended to wear laser safety goggles when operating the laser engraver.
• Avoid direct exposure of your skin to Class IV laser beams, especially at close range.
• Teenagers must be supervised by a parent or guardian while using the machine.
• Do not touch the laser engraving beam while it is active.

2. Material Safety

• Do not engrave materials with unknown properties.

• Recommended materials for engraving include: 

  Metals: stainless steel, aluminium, bronze, brass, alloys, etc. 

  Plastics: PP, PE, ABS, etc. 

3. Use Safety

• It is forbidden to point the laser to people, animals or any combustible object, whether it is in working condition or not.
• Use this laser engraving device only in accordance with all applicable local and national laws and regulations.
• Use this device only in accordance with this instruction manual and engraving software manual.
• Any untrained personnel who might be near the device must be informed the danger of the machine before operation

4. Electric Safety

• Only use this device with a compatible and stable power supply with less than 5% fluctuation in its voltage.
• Turn on the power to this device when it is well grounded.
• The area around this laser engraver device should be kept dry, well ventilated, and environmentally controlled to keep the ambient temperature between 40–95°F (5–35°C). The ambient humidity should not exceed 70%.

For more instructions and specifications, View Full ComMarker B6 Manual↗