B6 Maintenance

1. Maintenance Overview

NOTE: 

Unless otherwise specified, perform adjustment and maintenance ofthis device only when the power is turned off and the power supply has been disconnected. Only trained and skilled professionals should modify or disassemble this device.

2. Regular Maintenance Procedures

• Keep the workroom clean and dust-free at all times.
• Ensure the device is fully powered off when not in use.
• Cover the galvanometric lens when it is not in use.
• Clean the worktable after use with a cloth wetted with more than 75% rubbing alcohol.
• Never clean this device with abrasive or caustic cleansers, aerosol sprays, or enough water to enter any electrical component. Always allow surfaces to fully dry before further use.
• When removing dust from the device's vents using a vacuum, ONLY use the lowest power setting to avoid damage to internal components.

NOTE: 

No other servicing should be done by the operator. Do not attempt to service or replace other parts yourself.