ComMarker Safety Enclosure Pro manual

⚠Security Statement

1. To reduce the risk of fire or electric shock, do not expose this equipment to rain or moisture. 

2. Do not place objects filled with water such as a vase or the like, on top of or inside the apparatus. 

3. The enclosure is not intended to be used as a stepping object or table; objects may be placed on top of the enclosure that amount to no more than a total of 2 lbs.

Parts List and Installation

1. Framing Brackets and Hardware.

2. Assembly Procedure

①Peel off the protective film from the surface of the panels.
 

② Insert the panels into the groove of the aluminum profile column, and tighten the screws with a wrench. 
 

NOTE: 

The glossy side of the panels should face inward, and the matte side outward.

③Follow the method in the previous step to assemble the four side panels.

（Completed as shown in the picture）

④Attach the top panel of the Laser Engraver Enclosure and secure with screws at the four corners

⑤Fix one of the hinges to the door (transparent acrylic panel).

⑥Fix the other hinge to the front panel. Install the nuts onto the screws from inside the enclosure and secure the door.

⑦Install the door handle with the screw.

⑧Fix the sensor to the door and the front panel with four screws.

⑨Fix the wires of the sensor to the side wall of the panels with cable clips.

⑩Attach the LED light to the top of the inside of the cover

⑪Install the cable hole covers onto the holes on the back panel.

⑫Now, the ComMarker Acrylic Laser Engraver Enclosure is assembled
 

To download this manual, View Full ComMarker Safety Enclosure Pro Manual↗